Order today with Bajaao Express , and your product will dispatch in 24 hours
Special Import. Usually dispatches in 15-18 Days. Conditions Apply*
Special import. Dispatches in 5-8 days from International Warehouse. Conditions Apply*
This item is out of stock
From shimmering static and active phasing to frequency-adjustable flanging, the Flanger Hoax gives you an exciting new palette of textures to create with. Familiar and advanced modulation controls and 3 outputs (direct, blended, effect) let you create endless variations that will do everything from subtly shade to wildly animate your music.
The Flanger Hoax is made up of 2 separate phaser sections--the Fixed Phaser and Swept Phaser--and their associated delay lines. The Fixed Phaser is similar to a traditional phaser, modulated by a low-frequency sine wave called the Modulator. Each phaser circuit is followed by its own analog delay line, each of which can also be independently swept by the Modulator. Each phaser section can be bypassed to access the delay lines without any phase shift. Feedback control allows you to send the wet output of the pedal or the output of the Swept Phaser back into the phaser circuits. 18V power supply included.
BLEND knob: Mixes between the effect and the dry signal. The counter-clockwise position is all-dry, while the clockwise position is all effect. The result of the BLEND Control goes out the BLENDED OUTPUT jack
DELAY MODE switch: Selects between different phase shift combinations for the modulating waveform that sweeps the Fixed Phaser Delay line and the Swept Phaser Delay.
FEEDBACK knob: Sets the amount of signal that is fed back into both phase shift circuits. The counter-clocker-clockwise position gives you no feedback; the clockwise position yields maximum feedback.
OFF toggle switch position: All Feedback is turned off, no matter where the FEEDBACK knob is set.
RATE knob: Sets the frequency of the sine wave Modulator. The available frequency range is from 0.07 Hz (14 Seconds) to 220 Hz.
SWPT toggle switch position: In the SWPT Position, the output of the Swept Phaser is fed back into Phaser circuits.
WET toggler switch position: In the WET position, the wet signal (which is at the EFFECT OUTPUT Jack) is fed back to the phaser circuits.